= Sidewinder X2 =

== Cura ==

G-code de démarrage :

  G28 ; home all axes
  ; G29 ; Autoloveling a chaque impression
  M420 S1 Z10 ; Récupère l'autoleveling en mémoire et récupère la planeité sur 10mm
  M117 Purge extruder
  G92 E0 ; reset extruder
  G1 Z1.0 F3000 ; move z up little to prevent scratching of surface
  G1 X2 Y20 Z0.3 F5000.0 ; move to start-line position
  G1 X2 Y200.0 Z0.3 F1500.0 E15 ; draw 1st line
  G1 X2 Y200.0 Z0.4 F5000.0 ; move to side a little
  G1 X2 Y20 Z0.4 F1500.0 E30 ; draw 2nd line
  G92 E0 ; reset extruder
  G1 Z1.0 F3000 ; move z up little to prevent scratching of surface

G-code de fin :

  G91; relative positioning
   G1 Z1.0 F3000 ; move z up little to prevent scratching of print
   G90; absolute positioning
   G1 X0 Y200 F1000 ; prepare for part removal
   M104 S0; turn off extruder
   M140 S0 ; turn off bed
   G1 X0 Y300 F1000 ; prepare for part removal
   M84 ; disable motors
   M106 S0 ; turn off fan